Runco CL-810 / SDC-1, CL-810 CINEWIDE, CL-810 ULTRA manual Turning on the Power

Installation

Connecting to AC Power ➤ Projector: The CL-810 ships with various types of AC power cords. Choose the one that is appropriate to your locale.

Plug the female end of the power cord into the AC receptacle on the rear of the projector (AC 100V ~ 240V). Then, connect the other end to your AC power source.

Power switch

AutoScope Lens Motor: With AutoScope-equipped projectors, an additional power cord is provided for the lens motor. Plug the female end of the AC power cord into the AC input on the rear of the lens motor assembly. Connect the other end to a 110 VAC power source.

The input voltage to the AutoScope lens motor must be between

Caution 100 and 120 VAC. Do not connect the AutoScope lens motor to a 200-240 VAC power source!

3.7

Turning on the Power

AutoScope Lens Motor (Rear)

to

110 VAC Power

Power AC Input

Switch

1.Turn on your source components.

2.If this is an AutoScope-equipped projector, turn on the main power switch at the rear of the AutoScope lens motor. The lens motor power switch is located next to the AC input (see above).

3.Turn on the main power switch at the rear of the projector. The POWER LED lights orange. The LAMP and TEMP LEDs light red briefly, then go out.

4.Press the ON button on the remote control to turn on the CL-810. The POWER LED flashes orange to indicate that it is warming up.

5.When the projector is ready for use, the POWER LED lights green.

6.“Searching...” appears on the screen before the CL-810 identifies the input signal and remains there until a valid signal is detected.

7.If an incompatible input signal exceeds the range of the projector, a “No signal supported" message appears on the screen. This message remains on the screen until you change the input signal.

32 Runco CL-810 Series Owner’s Operating Manual