Runco CL-810 / SDC-1 When you change a setting in the Installation menu, the change, to exit

Operation

Installation ➤	To access the Installation adjustments, press MENU, then press the or button to
	highlight Installation and press ENTER. The Installation sub-menu, shown at left, appears.
Installation	Press EXIT to return to the previous menu or press MENU to close all menus.

Language
Picture Orientation		When you change a setting in the Installation menu, the change
Keystone Adjust	Note
		takes effect immediately; you do not need to press ENTER
Background Color		afterwards. (Press EXIT to return to the previous menu or MENU
RS-232 Baud Rate		to exit.)

Blue Image	Language: Press the		or	button to select from the available languages: English,
	French, Spanish, German and Italian.
	Picture Orientation: Press the				or	button to change the orientation of the projected
	image. The CL-810 can be installed on a ceiling or in a rear-screen configuration with one
	or more mirrors. There are four settings: Floor Front, Ceiling Front, Floor Rear and Ceiling
	Rear.
	Keystone Adjust: To correct distortion resulting from the angle of projection, select
	Keystone Adjust and use the				or	button to make the image rectangular.
	Tip	Runco recommends that the keystone feature not be used unless
		absolutely necessary, as it may cause artifacts in the image.
	Background Color: Press the				or	button to select the image Background Color
	(blue or white). The Background Color appears when no incoming signal is present.
	RS-232 Baud Rate: Press the				or	button to select the projector’s RS-232 Baud
	Rate. This function is used to change the transfer rate of the RS-232 connection. (This
	setting must match the data rate of the device connected to the RS-232 input.)
	Blue Image: Press the		or		button to turn the Blue Image Off or On. This feature
	removes all red and green color information from the image (simulating a blue filter), and is
	useful for color-calibrating the projector or other video components.
Option ➤	To access the Option adjustments, press MENU, then press the or button to
	highlight Option and press ENTER. When finished, press EXIT to return to the previous
Option	menu or press MENU to close all menus.
Reset Image Settings	Reset Image Settings: To restore the default image settings for the current input source
Sleep Timer
	ONLY, press the	button to highlight “Yes,” then press ENTER.
Lamp Hours
	Sleep Timer: The Sleep Timer automatically puts the projector into standby mode after
OSD Timer
	the amount of time you specify here. (A warning appears on-screen one minute before this
OSD Position
	is to occur.)
PC & HD Adjust
	Use the or	button to set the timer for anywhere from 10 minutes to 3 hours, in
PIP/PBP Set Up
	10-minute increments. To disable the Sleep Timer, set it to 0.
DNR
	Lamp Hours: To find out how long the projector lamp has been in use, select Lamp
	Hours and press ENTER.
	OSD Timer: Use the		or	button to set the OSD Timer. This timer controls how long
	the menus remain on-screen after selecting them. Select from 0 to 60 seconds, in
	3-second increments. When you set the OSD to 0, the menus remain on-screen until you
	hide them by pressing MENU.

56 Runco CL-810 Series Owner’s Operating Manual