Runco PL-50DHD, PL-43DHD manual Aspect Ratio, Power, Info, SET Button

PlasmaWall Service Remote Control

The PlasmaWall service remote control is intended for use only Note by authorized Runco dealers. Use it only as described here or as

instructed to by Runco Technical Support.

1.ASPECT RATIO

Press this button repeatedly to select a display aspect ratio (this may be necessary with certain computer resolutions).

2.POWER

Press to cycle the monitor between on and standby.

3.PC/HDTV-1

Selects INPUT 1 (ANALOG RGB IN) on the PlasmaWall.

4.HDTV-2

Selects INPUT 2 (DIGITAL RGB) on the PlasmaWall.

5.INFO

Displays timing information for the current input signal.

6.INSTALLER ADJUST (pin hole)

Used to access the INSTALLER ADJUST menu.

7.MENU

Pressing the MENU button brings up the main menu. Also, if you are in an adjustment mode or function, pressing MENU brings the menu back one level.

8.UP BUTTON

Use to move the menu cursor up in the On-Screen Display.

9.RIGHT BUTTON

Used to move the menu cursor right in the On Screen Display.

10.LEFT BUTTON

Used to move the menu cursor left in the On Screen Display.

11.DOWN BUTTON

Use to move the menu cursor down in the On-Screen Display.

12.SET BUTTON

When an item is highlighted on the On-Screen Display, the SET button selects the item.

A.2

Service/Setup Menu	Note	In order to use the PlasmaWall Service Remote Control, you must
		disconnect the PlasmaWall from the DHD Controller and connect a signal
		source to INPUT 1 on the PlasmaWall.

For the vast majority of installations, the DHD Controller remote control gives you all the control you need over display quality settings. However, there are two settings internal to the PlasmaWall that can improve the displayed image quality on INPUT 1: VIDEO NR (noise reduction) and MPEG FILTER. These settings can be found in the Setup Menu, shown in Figure A-2.

A-2 Runco PL-43DHD and PL-50DHD Owner’s Operating Manual