3. Installation
To install batteries in the remote control:
1.Press on the tab on the battery compartment cover and lift the cover in the direction of the arrow.
2.Insert the included batteries. Ensure that the polarities correctly match the 
and 
markings inside the battery compartment.
3.Close the battery compartment cover and press the tab on the cover until it clicks in place.
1 | 2 | 3 |
“AA” size
- |
+
+
-
3.1
Remote Control
• When installing batteries, make sure that the battery polarities are correct. | Notes on Batteries |
•Do not mix an old battery with a new one or different types of batteries.
•If you will not use the remote control for a long time, remove the batteries to avoid damage from battery leakage.
•Do not drop the remote control or expose it to moisture or high temperature.
•The remote control may malfunction under a fluorescent lamp. If that occurs, move the plasma display away from the fluorescent lamp.
•Make sure that there is nothing obstructing the infrared beam between the remote control and the IR receiver on the plasma display.
Note | The signal from the remote control can be reflected by walls or |
other surfaces. |
•If the effective range of the remote control decreases, or it stops working, replace the batteries with new ones.
•Ambient conditions may possibly impede the operation of the remote control. If this happens, point the remote control at the plasma display and repeat the operation.
CinemaWall Installation/Operation Manual | 11 |
