249Car care and technical information
5 Turn on the low beam headlights and
place a piece of cardboard or equivalent
(although not directly on the lens) in front
of the headlight not being aimed. This
should allow the beam cut-off of the
headlight being aimed to be seen on the
flat surface.
6 Turn the vertical aiming screw until the
horizontal cut-off of the headlight is
aligned with the horizontal line on the
wall.
NOTICE
Do not cover a headlight directly on the
lens to improve beam cut-off when aim-
ing. Covering a headlight may cause
excessive heat build-up which may cause
damage to the headlight.
IB1951

Vertical aiming device

IB1952

Aiming marker on headlight lens

IB1953

Horizontal line on wall or other flat surface

IB1954

Correctly adjusted low beam

95_U S_M 07.book Page 249 Friday, June 9, 2006 8:58 AM