Manuals / Samsung / Household Appliance / Air Conditioner

Samsung ASV13PUQXXEA If may not be a, Outdoor unit Heat exchanger during Heat mode in winter

Models: ASV18PUQXXEA ASV10PUQNXEA ASV18PSPXXEA ASV10PUQXXEA ASV24PUQNXEA ASV18PUQNXEA ASV24PUQXXEA ASV13PSPXXEA ASV10PSPXXEA ASV13PSPNXEA ASV18PSPNXEA ASV24PSPNXEA ASV13PUQNXEA ASV10PSPNXEA ASV24PSPXXEA ASV13PUQXXEA

1 41

Page 21

PROBLEM	SOLUTION

Error is indicated.	• When an indoor unit indicator blinks, contact the nearest service center.

Noise is generated.	• Depending on the status of the air conditioner usage, noise can be heard when refrigerant

Smoke is generated from	• If may not be a	but it can be a steam generated by the defrost operation from outdoor
the outdoor unit.	heat exchanger during Heat mode in winter.

Water is dropping from	•
the outdoor unit piping
connection.

ENGLISH

Page 21

Image 21

Samsung ASV13PUQXXEA, ASV13PSPNXEA If may not be a, Outdoor unit Heat exchanger during Heat mode in winter, Connection

Contents

Air Conditioner Contents Important safety symbols and precautions Safety precautionsFollow directions Wall socket For Using For Cleaning Operation ranges Checking before use Checking the name of the parts Power buttonMain parts Display Remote controller buttons Checking the remote controller Battery changing time Remote controller displayStoring the remote controller Inserting the batteries Basic function Press Button to adjust the temperature Press the Air swing button on the remote controller Using the Turbo functionCirculate the air Position you prefer Mode Press the button Press the button to set the time Press the Set/Cancel button to active it on Timer 1 hour Using the Smart Saver functionTimer 5 hours From the moment you have set the timer Using the Quiet function Cleaning the outdoor unit heat exchanger Cleaning the indoor unitOpening the panel Heat exchanger Clean the Air Cleaning the air conditionerSlide it down Dry the Ai lter in a ventilated area Periodical checks Maintaining the air conditioner Troubleshooting Outdoor unit Heat exchanger during Heat mode in winter If may not be aConnection Model Name Included Models Remark General information Installing the unit Choosing the installation locationPower supply line, fuse or circuit breaker Won’t be considered in-warranty and charged to end user Model Outdoor Unit When installing more than 1 outdoor unit  When the air outlet is towards the wallTop view Side view Accessories Accessories in the indoor unit caseAccessories in the outdoor unit case Optional accessories Fixing the installation plateTools required for installation General Tools Tools for test operations Connecting the assembly cable Connecting the cableFix the indoor unit Each wire is labeled with the corresponding terminal number Extend the assembly cable if necessary Then pull it out through the appropriate hole Smooth the cut edges Cutting or extending the pipe Purging the indoor unitUnscrew the caps at the end of each pipe Connect the pipes Cracked Correct InclinedApplying the following torque Outer Diameter Changing direction of the drain hose Drain hose installation Excessive torque can be cause of gas leakage Purging the connected pipes Adding Refrigerant Covered by the Kyoto Protocol 1975 To check for gas leaks on the outdoor unit Performing the gas leak testsTo check for gas leaks on the indoor unit Leak test with nitrogen before opening valves Fixing the outdoor unit in place Outdoor unit installed on the wall by rackPart without insulation on the end of the pipes Properly Model Press the Power button and check the following Pump down procedure when removing the productPress the Mode button to select Cool or Heat mode Final Check and Trial Operation How to connect your extended power cables Questions or COMMENTS?

PROBLEM

• If may not be a

the outdoor unit.

heat exchanger during Heat mode in winter.

connection.