Troubleshooting
Refer to the following chart if the air conditioner operates abnormally. This may save time and unnecessary expenses.
PROBLEM | SOLUTION |
|
|
|
| |||
|
|
|
|
|
| |||
The air conditioner does | • | Check power status and then operate the air conditioner again. | ||||||
not work at all. | • | Plug in or switch on the circuit breaker and then operate the air conditioner again. | ||||||
| • | Check if you have set the | Timer. Operate the air conditioner again by pressing the | |||||
|
| Power button. |
|
|
|
| ||
|
|
|
|
|
| |||
The temperature | • | Check if you have selected Fan/Turbo mode. In these modes, desired temperature is set to | ||||||
adjustment is not working. |
| auto and you cannot adjust the temperature. |
|
| ||||
|
|
|
|
|
| |||
Cool/Warm air does | • | Check if the set temperature is higher(during Cool mode)/lower(during Heat mode) than | ||||||
not come out of the air |
| the current temperature. Press the Temp + or - button on the remote controller to change | ||||||
conditioner. |
| the set temperature. |
|
|
|
| ||
| • | Check if the Air | is blocked by dirt. If there is a lot of dust on the Air | |||||
|
| cooling(heating) performance may decrease. Clean them frequently. | ||||||
| • | Check if the outdoor unit is covered or installed near the obstacle. Take the cover and | ||||||
|
| take the obstacle away. |
|
|
| |||
| • If you want to operate the air conditioner in the sunlight, cover the outdoor unit using | |||||||
|
| curtains or etc. |
|
|
|
| ||
| • Check if the air conditioner is operating in | |||||||
|
| or the outdoor temperature is too low, the air conditioner operates in | ||||||
|
| automatically. In | ||||||
| • If the doors or windows are open, it may cause bad cooling (heating) performance. | |||||||
|
| Close the doors and windows. |
|
| ||||
| • Check if the air conditioner has just been turned on after stopping cooling(heating) | |||||||
|
| operation. In this case, just a fan will run to protect the outdoor unit compressor. | ||||||
| • Check if the pipe length is too long. When the pipe length exceeds maximum allowable | |||||||
|
| pipe length, cooling (heating) performance may decrease. | ||||||
|
|
|
|
|
|
| ||
working. | • | Check if you have selected Auto/Dry/ | mode. In these modes, desired | |||||
| temperature is set to auto and you cannot adjust the temperature. | |||||||
|
|
|
|
|
|
| ||
Fan speed adjustment is | • | Check if you have selected Auto/Dry/Turbo/ | mode. In these mode, fan speed | |||||
not working. |
| is set to Auto and you cannot adjust the fan speed. | ||||||
|
|
|
|
|
|
| ||
Remote controller is not | • | Check if your batteries are depleted. |
|
| ||||
working. | • | Make sure nothing is blocking your remote controller sensor. | ||||||
| • Check that there are strong lighting apparatus near the air conditioner. Strong light which | |||||||
|
|
|
|
|
| |||
Timer function does not | • | Check if you press the Set/Cancel button on the remote controller after you have set the time. | ||||||
set. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The indicator is blinking | • | Press the Power |
|
|
|
|
|
|
|
|
|
|
| ||||
|
|
|
|
| ||||
continuously. |
| switch. |
|
|
|
| ||
|
| If the indicator is still blinking, contact the service center. | ||||||
|
|
|
|
|
| |||
Odors permeate in the | • | Check if the appliance is running in a smoky area. Ventilate the room or operate the air | ||||||
room during operation. |
| conditioner in Fan mode for 1~2 hours. (We do not use smelly components in the air | ||||||
|
| conditioner.) |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
20
