getting started

This chapter gives you step-by-step instructions for setting up the machine.

This chapter includes:

Setting up the hardware

Printing a demo page

System requirements

Setting up the network

SETTING UP THE HARDWARE

This section shows the steps to set up the hardware which is explained in the Quick Install Guide. Make sure you read Quick Install Guide and complete following steps.

1.Select a stable location.

Select a level, stable place with adequate space for air circulation. Allow extra space to open covers and trays.

The area should be well-ventilated and away from direct sunlight or sources of heat, cold, and humidity. Do not set the machine close to the edge of your desk or table.

Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the altitude setting to optimize your printing. See "Altitude adjustment" on page 27 for more information.

Place the machine on a flat and stable surface, not letting it lean more than 2 mm (0.08 inches). Otherwise, it may affect the printing quality.

2.Unpack the machine and check all the enclosed items.

3.Remove the tape holding the machine tightly.

Using a wired network

Using a wireless network(CLP-310W,CLP-315W only)

Machine's basic settings

4.Load paper. (See "Changing the size of the paper in the paper tray" on page 31.)

5.Make sure that all the cables are connected to the machine.

6.Turn the machine on.

When you move the machine, do not tilt or turn it upside down. Otherwise, the inside of the machine may be contaminated by toner, which can cause damage to the machine or bad print quality.

PRINTING A DEMO PAGE

Print a demo page to make sure that the machine is operating correctly. To print a demo page:

In ready mode, press and hold the Stop button for about 2 seconds.

SYSTEM REQUIREMENTS

Before you begin, ensure that your system meets the following requirements:

Windows

Your machine supports the following Windows operating systems.

OPERATING

REQUIREMENT (RECOMMENDED)

 

 

 

 

 

 

SYSTEM

CPU

RAM

FREE HDD

 

SPACE

 

 

 

Windows

Pentium II 400 MHz

128 MB

600 MB

2000

(Pentium III 933 MHz)

(256 MB)

 

Windows XP

Pentium III 933 MHz

128 MB

1.5 GB

 

(Pentium IV 1 GHz)

(256 MB)

 

Windows

Pentium III 933 MHz

128 MB

1.25 GB to

Server 2003

(Pentium IV 1 GHz)

(512 MB)

2 GB

Windows

Pentium IV 3 GHz

512 MB

15 GB

Vista

 

(1024 MB)

 

Windows

Pentium IV 1 GHz

512 MB

10 GB

Server 2008

(Pentium IV 2 GHz)

(2048 MB)

 

 

 

 

 

• Internet Explorer 6.0 or higher is the minimum requirement for all Windows operating systems.

Users who have an administrator right can install the software.

Windows Terminal Services is compatable with this machine.

20 _Getting started

Page 20
Image 20
Samsung CLP-310 manual Getting started, Setting UP the Hardware, Printing a Demo, System Requirements, Windows