PDP (Continued)
Problem | Possible Solution |
If the message “No Wireless Signal | Check whether the WIRELESS HOME AV CENTER’s Power |
or Please Check WIRELESS HOME | is turned ON. Check whether the Wireless LED on the |
AV CENTER Power” appears: | front panel is lit Green (If not, move the WIRELESS HOME |
This message is displayed when the | AV CENTER to a location where the Green LED lights up). |
communication between the PDP and |
|
the WIRELESS HOME AV CENTER |
|
fails. |
|
|
|
PDP set is turned on and the message |
|
“No Wireless Signal or Please Check |
|
WIRELESS HOME AV CENTER |
|
Power” appears. |
|
Cause 1: The WIRELESS HOME AV | Solution 1: Turn on the PDP set and then turn on the AV |
CENTER is turned off. | Center as they have separate power supplies. |
Cause 2: The message still appears | Solution 2: Check if AV Receiver’s LED at the top of PDP |
despite the AV Center is on. | set and the AV Center’s wireless LED are ON and green. |
| If both are OFF, change both devices’ positions so that |
| they face each other for better communication. If the |
| message appears again, turn both PDP and AV Center |
| OFF and then turn them back ON. If the problem persists, |
| contact the nearest service center. |
|
|
The picture continuously breaks up |
|
and the message “No Wireless |
|
Signal or Please Check WIRELESS |
|
HOME AV CENTER Power” appears. |
|
Cause: The product utilizes 5GHz | Solution: During watching, another wireless device that |
band for wireless signal transmission. | uses a single fixed frequency of the same band may |
Other wireless devices may cause | interfere and cause this problem. In this case, turn the |
picture noise or communication | PDP and AV Center off and then back on. The WIRELESS |
errors. These problems may be | HOME AV CENTER has the function of frequency search |
caused by Wireless PC networks or | in the 5GHz band for clear data communication to avoid |
wireless TV sets using the same band. | signal interference. |
|
|
The message “Please check |
|
resolution, AV Center can’t support |
|
720p/1080i component signal.” |
|
appears in the Component Mode. |
|
Cause: AV Center only handles of | Solution: Switch the input source to 480i or 480p. |
480i and 480p input. 720p and |
|
1080i input cannot be processed. |
|
|
|
79
