Samsung HP-P5091 manual Pdp

PDP (Continued)

Problem	Possible Solution
There is no signal in a digital chan-
nel, and messages “Searching for
Signals” followed by “No Signal”
appear.
Cause: Channels have been stored	Solution: Select an alternative channel or switch the
using Auto Memorize but the	external input source.
broadcasting companies are not
sending the corresponding signals.
Or External Input has been selected
but there is no signal.
The message “Not supported sound
format” appears.
Cause: Digital Audio rather than	Solution: AV Center cannot handle the Audio Mode
AC-3 (such as DTS, MPEG-1 or	except AC-3. Switch the input to AC-3, or alternatively
MPEG-2) was entered for Audio	select Set-Up in the Menu, move to Sound In/Out then
when SPDIF Input is selected in the	switch Digital Input to Lt/Rt.
Component Mode resulting in	Note: Digital Audio inputs except AC-3 might cause a
displaying this message with no
	severe damage to the system. Please use Dolby Digital
picture.
	as a digital audio input.
The picture quality is poor in the
Component Mode despite setting
480p.
Cause: To enable the wireless signal	Solution: MPEG Encoding of 480p is not possible in
transmission for 480p input, it is	the current consumer electronics technology as it is,
converted to 480i before MPEG	so viewing the original 480p picture quality is limited.
Encoding.
After selecting the STB Mode of the
Remote Control, AV Center does not
respond to the Remote Control.
Cause: The Remote Control of AV	Solution: Set the Remote Control to the TV Mode and
Center only turns power ON and	perform all controls on the PDP.
OFF, but cannot respond to other
Remote Control keys.
The message “Not available in the
current mode.” appears.
Cause: Input of unavailable function	Solution: Please try to use other menu keys that are
keys (e.g. trying to switch a channel	available.
in External Input mode) may cause
the message to appear.

80