Installing the Display on the Wall Attachment Panel
See the drawing of the wall attachment panel shown in page 14 to check for
1 the stability of the wall where the PDP is to be installed. If the wall is not enough strong to support the PDP, strengthen the wall before installation.
Fix the wall attachment panel on the wall using bolts as shown in the following
2 figure: Fixing bolts must protrude from the wall appox. 0.6 inches.
Using the wall attachment panel, you may adjust the angle of the display from
3 0 to 20 degrees. The angle can be set in 5 stages with 5 degrees of distance each using the angle control holes on the sides of the panel.
When the angle has been set to 5 degrees.
Angle control holes
When the angle has been set to 15 degrees.
When the panel hasn't been tilted.
5degrees of tilt
10degrees of tilt
15degrees of tilt
No tilt 
20 degrees of tilt
Continued...
15
