7System

7.1Multi Control

MENU [m] System Multi Control ENTER [ ]

Assign an individual ID to your product.

7.1.1 Configuring settings for Multi Control

ID Setup

Assign an ID to a set. (Range: 0~99)

Press or to select a number, and press [].

ID Input

Enter the ID number of the product connected to the input cable for input signal reception. Enter the number you want using the number buttons on the remote control.

MDC Connection

Select a method to connect to MDC to receive the MDC signal.

RS232C MDC

Communicate with MDC via the RS232C-stereo cable.

RJ45 MDC

Communicate with MDC via the RJ45 cable.

DisplayPort daisy chain(DisplayPort Daisy Chain)

To display the [DP IN] video input through the [DP OUT] output port, select a device connection method from Single Stream Transport (SST) and Multi Stream Transport (MST).

Clone: In this Single Stream Transport (SST) output mode, the same screen output is displayed on two display devices connected.

- If Clone is selected, the PC recognizes the two displays as a single monitor.

-Clone mode is enabled if the input source is a digital input other than DisplayPort, such as DVI, HDMI, MagicInfo or PIM.

Expand: In this Multi Stream Transport (MST) mode, a different screen output is displayed on two display devices connected.

- If Expand is selected, the PC recognizes the two displays as separate monitors.

-The mode functions only on a PC that supports DisplayPort 1.2 MST.

-For Full HD resolution (1920x1080) displays, a maximum of four displays can be connected.

Refer to page 74 for details about the MDC menu.

7 System 145