1.5 <

Introduction>
Selecting a location
Select a level, stable place with adequate space for air circulation. Allow
extra space for opening covers and trays.
The area should be well-ventilated and away from direct sunlight or
sources of heat, cold, and humidity. Do not set the printer close to the
edge of your desk or table.

Clearance space

Front: 482.6 mm (enough
space so that trays can be
opened or removed)
Back: 320 mm (enough space
to allow opening of the rear
cover or the duplex unit)
Right: 100 mm (enough space
to allow opening of the control
board cover)
Left: 100 mm (enough space
for ventilation)
Note
• When you move the printer, do not tilt or turn it upside down,
otherwise the inside of the printer may be contaminated by
toner, which can cause damage to the printer or bad printing
quality.