getting started
This chapter gives you
This chapter includes:
•Setting up the hardware
•System requirements
•Setting up the network
SETTING UP THE HARDWARE
This section shows the steps to set up the hardware which is explained in the Quick Install Guide. Make sure you read Quick Install Guide and complete following steps.
1.Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow extra space to open covers and trays.
The area should be
•Installing the software
•Machine's basic settings
2.Unpack the machine and check all the enclosed items.
3.Remove the tape holding the machine tightly.
4.Install the toner cartridge.
5.Load paper. (See "Loading paper" on page 34.)
6.Make sure that all the cables are connected to the machine.
7.Turn the machine on.
When you move the machine, do not tilt or turn it upside down. Otherwise, the inside of the machine may be contaminated by toner, which can cause damage to the machine or bad print quality.
This equipment will be inoperable when mains power fails.
Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the altitude setting to optimize your printing. See "Altitude adjustment" on page 26 for more information.
Place the machine on a flat, stable surface so that there is no incline greater than 2 mm (0.08 inch). Otherwise, printing quality may be affected.
22 _Getting started
