Samsung SCX-6545N Series manual Changing the Size of the Paper in the Paper Tray

MEDIA TYPE		GUIDELINES
Transparencies	• To avoid damaging the machine, use only
	transparencies designed for use in laser printers.
	• Transparencies used in the machine must be able
	to withstand 180 °C, the machine’s fusing
	temperature.
	• Place them on a flat surface after removing them
	from the machine.
	• Do not leave them in the paper tray for long periods
	of time. Dust and dirt may accumulate on them,
	resulting in spotty printing.
	• To avoid smudging caused by fingerprints, handle
	them carefully.
	• To avoid fading, do not expose printed
	transparencies to prolonged sunlight.
	• Ensure that transparencies are not wrinkled, curled,
	or have any torn edges.
Labels	• To avoid damaging the machine, use only labels
	designed for use in laser machines.
	-	When selecting labels, consider the following fac-
		tors:
	-	Adhesives: The adhesive material should be sta-
		ble at your machine’s fusing temperature. Check
		your machine’s specification to view the fusing
		temperature, see page 126.
	-	Arrangement: Only use labels with no exposed
		backing between them. Labels can peel off sheets
		that have spaces between the labels, causing
		serious jams.
	-	Curl: Prior to printing, labels must lie flat with no
		more than 13 mm of curl in any direction.
	-	Condition: Do not use labels with wrinkles, bub-
		bles, or other indications of separation.
	• Make sure that there is no exposed adhesive
	material between labels. Exposed areas can cause
	labels to peel off during printing, which can cause
	paper jams. Exposed adhesive can also cause
	damage to machine components.
	• Do not run a sheet of labels through the machine
	more than once. The adhesive backing is designed
	for only a single pass through the machine.
	• Do not use labels that are separating from the
	backing sheet or are wrinkled, bubbled, or otherwise
	damaged.
Card stock or	• Do not print on media smaller than 98 mm wide or
custom-sized	356 mm long.
materials	• In the software application, set margins at least
	6.4 mm away from the edges of the material.

MEDIA TYPE	GUIDELINES
Preprinted	• Letterhead must be printed with heat-resistant ink
paper	that will not melt, vaporize, or release hazardous
	emissions when subjected to the printer’s fusing
	temperature for 0.1 second. Check your machine’s
	specification to view the fusing temperature, see
	page 126.
	• Letterhead ink must be non-flammable and should
	not adversely affect printer rollers.
	• Forms and letterhead should be sealed in a
	moisture-proof wrapping to prevent changes during
	storage.
	• Before you load preprinted paper, such as forms
	and letterhead, verify that the ink on the paper is
	dry. During the fusing process, wet ink can come off
	preprinted paper, reducing print quality.

CHANGING THE SIZE OF THE PAPER IN THE PAPER TRAY

To load longer sizes of paper, such as Legal-sized paper, you need to adjust the paper guides to extend the paper tray.

1 paper length guide

2 paper width guide

If you have installed an optional high capacity feeder, refer to Quick Install Sheet to adjust paper size.

1.Adjust the paper length guide to the desired paper length. It is preset to Letter or A4 size depending on the country. To load another size, hold the lever and move the length guide to the corresponding position.

37 _Loading originals and print media