Samsung SNB-3002 System, Power, On While the power is on, SD Indicators OFF If the power is off

overview

Item		Description
System, Power,	POWER	ON : While the power is on
c SD Indicators		OFF : If the power is off
	Resets the camera settings to the default. Press and hold for about 5
	seconds to reboot the system.
Reset Button	J If you reset the camera, the network settings will be adjusted so that
	DHCP can be enabled. If there is no DHCP server in the network, you
	must run the IP Installer program to change the basic network settings
	such as IP address, Subnet mask, Gateway, etc., before you can connect
	to the network.
Power Port	Used to plug the power cable.
GND	Used for earth-grounding.
Network Port	Used to connect a PoE or Ethernet cable.
	ALARM IN	Used to connect the alarm input signal.
	ALARM OUT	Used to connect the alarm output signal.
I/O Port	ALARM COM	Common port where the alarm output signal is connected.
	GND	Used for earth-grounding.
	RS-485+	Port used for connecting to the pan/tilt receiver.
	RS-485-	Port used for connecting to the pan/tilt receiver.
Video Out Port	Analog video output port. (for installation)

J The RS-485+/- ports are used to directly connect the Pan/Tilt receiver for data transfer.

14_ overview