Network disconnect

You can perform the saving/relay/preset operation after receiving an event of a physically disconnected network.

1.From the Setup menu, select the

<Event ( )> tab.

2.Click <Network disconnect>.

3.Specify the use of “Network disconnect”.

4.Specify the activation time and activation condition.

For more information about <Activation time> and <Action>, refer to “Alarm input”. (page 66)

5.When done, click [Apply ( )].

Tampering

You can set to trigger an event when a scene is changed on the video screen.

1.From the Setup menu, select the

<Event ( )> tab.

2.Click <Tampering>.

3.Specify the use of the scene change, and if you set to use it, select a sensitivity.

The higher the sensitivity is, the lesser change can be detected.

4.Specify the activation time and activation condition.

For more information about <Activation time> and <Action>, refer to “Alarm input”. (page 66)

5.When done, click [Apply ( )].

JThe default change detection function may not work properly in the following cases:

-A monotonous background or a night/low-contrast scene may deteriorate the detection performance.

-A severe shaking of the camera or a drastic change to the illumination can be considered a scene change by mistake.

SETUP SCREEN

English _69

Page 69
Image 69
Samsung SNB-3002 user manual Network disconnect, Tampering