Samsung VR10F71UCBC/EO manual Charging, Discharged, and you must charge the vacuum cleaning robot

Charging

When the product is initially purchased, the battery is fully	Charging lamp
discharged, and you must charge the vacuum cleaning robot	Power lamp
manually.

Turn on the Power Switch at the bottom of the product.

1.After aligning the charge pins of the main unit with the charge pin of the charger station, press the main unit until you hear a Recharging power sound from the charger.

- The Charging Lamp turns green.

Power lamp Charging lamp

2.Check the charge status of the vacuum cleaning robot.

-When charging starts, “the amount of remaining battery power”

and “ ” are displayed on the status display panel in this sequence.

-When charging is complete, the battery level indicator and “FULL” will be displayed in the display panel.

Charging Fully charged

Flash

Flash

■When the battery level display fl ashes while cleaning, the vacuum cleaning robot stops vacuuming and automatically charges itself at the charger.

■If the vacuum cleaning robot starts the current cleaning run at a location other than the charging station and fails to locate the charging station while cleaning, it will stop near the location where it started cleaning.

■When the battery level fl ashes and “Lo” is displayed while cleaning, vacuum cleaning robot cannot be operated by the remote control or the buttons on the main unit. In this case, directly carry the vacuum cleaning robot to the charger to charge the battery. (This is when the battery is completely discharged.)

<Charge display>

Charge Charging Required

completecharging

22_ operating