Samsung VR10F71UCBC/SW, VR10F71UCBC/EG, VR10F71UCBC/EO manual Manual Cleaning, Remote control button

Manual Cleaning

You can move the vacuum cleaning robot to clean a particular location directly by using the remote control.

■Move the vacuum cleaning robot to the location where you want to perform manual cleaning.

■You can manually clean using the remote control only.

Remote control button Configuration Sequence

1. Set the mode.

2. Cancel the mode.

• When the vacuum cleaning robot is docked with the

NOTE

charger station, manual cleaning is not supported.

•If there is no input for about 1 minute to switch to standby mode.

•	Each time you press the Turbo button, the Turbo icon on
CAUTION	the display panel is turned on or off sequentially. When the
	Turbo icon is turned on, you can start cleaning in Turbo
	mode.

•Each time you press the Dust Sensor button, the Dust Sensor icon on the display panel is turned on or off sequentially. When the Dust Sensor icon is turned on, you can start cleaning in Dust Sensor mode.

Directional Buttons (Forwards, Left, Right)

A backwards function is not supported.

32_ operating