CAUTION Before use▶▶Insert the dustbin before using POWERbot.

▶▶Open room doors before cleaning in order to have all rooms cleaned and install a Virtual guard in front of entryway, balconies, bathrooms, or other areas where POWERbot may fall.

▶▶Be careful with the followings for proper automatic recharging.

––Always turn on the power of the charger.

––Install the charger where POWERbot can easily find.

––Do not leave any object in front of the charger.

▶▶When installing the charger, do not leave the cord carelessly on the floor since POWERbot may get tangled by it.

▶▶Do not use POWERbot on black colored floors.

––The POWERbot may not be able to operate normally.

▶▶Do not pick up POWERbot by the dustbin holder.

▶▶Do not place any objects within 0.5 m to both sides and 1 m to the front of the charger.

▶▶Make sure the charger's charging contact is not damaged or have any foreign matters on it.

▶▶Do not install the charger in an area with a dark floor.

––If the floor around the charger is dark, recharging is hindered.

▶▶Move any obstacles that may disturb POWERbot's movement (such as children's indoor swing or slides) before cleaning.

CAUTION In use

▶▶Using POWERbot on thick carpet may damage both POWERbot and the carpet.

––The POWERbot cannot pass over carpet that is thicker than 1 cm.

▶▶Do not use POWERbot on tables or other high surfaces.

–– There is a risk of damage if it falls.

▶▶The POWERbot may bump into chair, desk legs therefore move them away for faster and efficient cleaning.

▶▶When POWERbot is operating, do not lift it up or carry it to another area.

▶▶Do not hold by driving wheels of POWERbot when carrying it to another area.

▶▶Do not put any objects on top of POWERbot since it may cause malfunction.

▶▶Remove any large papers or plastic bags immediately when using POWERbot since they may block the intake.

▶▶Do not aim the red pointer directly at people or animals.CAUTION Cleaning and maintenance

▶▶Prevent any damage to POWERbot by complying the followings.

––Do not clean POWERbot by spraying water directly onto it or use benzene, thinner, acetone or alcohol to clean it.

▶▶Do not disassemble or repair POWERbot. This should only be done by a certified repairman.

▶▶Always keep the obstacle sensor and cliff sensor clean.

––If foreign matter accumulates, sensors may malfunction.

ENGLISH-07