Troubleshooting
Troubleshooting
Problem | Action | |
|
| |
| • Plug the power cord into a live electrical outlet. | |
| • Check the fuse or reset the circuit breaker. | |
| • Close the door and press and hold Start/Pause (Hold to Start) | |
| to start the washing machine. For your safety, the washing | |
| machine will not tumble or spin unless the door is closed. | |
| • Before the washing machine starts to fill, it will make a series | |
| of clicking noises to check the door lock and does a quick | |
Stops. | drain. | |
• There may be a pause or soak period in the cycle. Wait briefly | ||
| ||
| and the washing machine may start. | |
| • Make sure the mesh filter of the water supply hose at the | |
| water taps is not clogged. Periodically clean the mesh filter. | |
| • If the washing machine is not supplied with sufficient power, | |
| the washing machine temporarily will not drain or spin. As | |
| soon as the washing machine regains sufficient power, it will | |
| operate normally. | |
| • Fully open both taps. | |
| • Make sure the temperature selection is correct. | |
| • Make sure the hoses are connected to the correct taps. Flush | |
| water lines. | |
| • Make sure the water heater is set to supply a minimum 120 °F | |
| (49 °C) hot water at the tap. Also, check the water heater | |
| capacity and recovery rate. | |
Fills with the wrong | • Disconnect the hoses and clean the mesh filter. The mesh | |
filter may be clogged. | ||
water temperature. | ||
• While the washing machine fills, the water temperature may | ||
| ||
| change as the automatic temperature control feature checks | |
| incoming water temperature. This is normal. | |
| • While the washing machine fills, you may notice just hot and/ | |
| or just cold water going through the dispenser when cold or | |
| warm temperatures are selected. This is a normal function | |
| of the automatic temperature control feature as the washing | |
| machine determines the water temperature. | |
| • Use the High or Extra High spin speed. | |
Load is wet at the | • Use high efficiency (HE) detergent to reduce oversudsing. | |
• Load is too small. Small loads (one or two items) may become | ||
end of a cycle. | ||
unbalanced and not spin completely. | ||
| ||
| • Make sure the drain hose is not kinked or clogged. | |
|
|
60 English
|
| 2018/2/21 10:04:53 | |
|
| ||
|
|
|
|