Sanyo E11A202U 7.2 External Interface Connections, Connected an optional LAN interface card, Connect a computer or option card as required

③Connect the input power plugs of the load devices to the output terminals.

For E11A202U001

The total load connected to	For E11A202U001J
the output terminals must
not exceed 20A.

MODEL	Output terminal capacity	Note
	125V 20A receptacle ⋅ 4pcs.	If you must make a single-wire
E11A202U001	(NEMA 5-20R)	grounded connection, always	U
	The total output from all	connect the ground phase to the	E
	output receptacles must not	V terminal (phase) side.	V(W)
			(Or, N)
	exceed 2.0kVA（1.4kW）
		If you must make a single-wire
	125V 30A receptacle ⋅ 1pcs.		U
	(NEMA L5-30R)	grounded connection, always
E11A202U001J	The total output from all	connect the ground phase to the	E
	output receptacles must not	V terminal (phase) side.	V(W)
	exceed 2.0kVA（1.4kW）
			(Or, N)

7.2 External Interface ConnectionsConnect a computer or option card as required.For details, see §5.3 “External Interfaces” and §10 “User Settings”.

Note

The CARD I/F and PC I/F connectors cannot be used at the same time.

7.2.1 Connections to the PC Interface (PC I/F)

Connect a computer to the PC I/F connector to control the UPS by using the supplied power management software.

Install the power management software on the computer, and connect the computer to the UPS with the supplied network cable. For more information, refer to the Install Guide or User Guide in the CD-ROM of the power management software.

Before making the connection, check that item ⑤ “PC Interface mode” in §10.1 “Setup Menu Item List” is set as follows.

Interface mode*: Workstation mode

7.2.2 Connections to the Card Interface (CARD I/F)Connected an optional LAN interface card.

Before making the connection, check that item ⑤ “PC Interface mode” in §10.1 “Setup Menu Item List” is set as follows.

Interface mode*: Workstation mode

Note

This connector is for use with Sanyo option cards only. Contact your supplier for more information about option cards.

*Use the control panel to set the interface mode. For more information, see item ⑤ Interface mode in §10.1 “Setup Menu Item List”.

−17 −