Sanyo MPR-1411R instruction manual Setting Of Alarm Resume Time

SETTING OF ALARM RESUME TIME

The alarm buzzer and remote alarm are silenced by pressing he alarm buzzer stop key (BUZZER) on the control panel during alarm condition. The buzzer and remote alarm will be activated again after certain suspension if the alarm condition is continued. The suspension time can be set by following the procedure shown in the Table 5 below.

The example in the table is based on the assumption that the desired duration is 20 minutes. Note: The duration is set in 30 minutes at the factory.

Table 5 Procedure for setting of alarm resume time (Example: change from 30 minutes to 20 minutes)

	Operation	Key operated	Indication after operation
1		-----	The current chamber temperature
			is displayed.
2	Press and hold the numerical value		The first digit of the temperature
	shift key for about 5 seconds.		display blinks.
	Set to F25 by using digit shift key		Pressing the key leads the change of flashed
3			digit.
	and numerical value shift key.		Pressing the key shifts up the figure
			of the current digit.
			The current set value is displayed and
4	Press the set key.	SET	the second digit of the temperature
			display flashes.
5	Set to 020 by using numerical value		Pressing the key shifts up the figure in
	shift key.		the second digit.
6	Press the set key.	SET	The value is stored in memory and
			the current chamber temperature is
			displayed.

Note:

•The settable alarm resume times are 10, 20, 30, 40, 50, or 60 minutes (The set values are 010, 020, 030, 040, 050, and 060). The buzzer would not reset if the resume time is set in 000.

•The set mode returns to the temperature display mode automatically when 90 seconds has passed without any key operation. In this case, any setting before pressing set key (SET) is not memorized.

19

- 57 -