Sanyo PLC-WL2500 owner manual Part Names and Functions Side Terminal, ① LAN Connection Terminal

Part Names and Functions

Side Terminal

① ② ③ ④ ⑤ ⑥ ⑦

⑩ ⑨ ⑧

① LAN Connection Terminal ⑥ AUDIO OUT (VARIABLE)

Connect the LAN cable (refer to the owner’s manual of "Network Set-up and Operation").

②HDMI

Connect the HDMI signal from computer or video equipment to this terminal (pp.14,16).

is registered trademarks of HDMI Licensing, LLC.

③COMPUTER IN 1 / COMPONENT IN

Connect output signal from a computer, RGB scart 21-pin video output or component video output to this terminal (pp.14,16).

④COMPUTER IN 2/MONITOR OUT

This terminal is switchable and can be used for input from a computer or output to the other monitor. Set the terminal up as either Computer input or Monitor output properly. [Used for Monitor out, this terminal outputs only incoming signal from COMPUTER IN 1/COMPONENT IN terminal (pp. 14, 50)].

⑤S-VIDEO IN

Connect the S-VIDEO output signal from video equipment to this jack (p.15).

Connect an external audio amplifier to this jack (pp.14-16).

This terminal outputs sound from AUDIO IN terminal (⑧ or ⑨) or HDMI terminal ② (digital

audio).

⑦CONTROL PORT

When controlling the projector with RS-232C, connect the control equipment to this connector with the serial control cable.

⑧COMPUTER / COMPONENT AUDIO IN

Connect the audio output (stereo) from a computer or video equipment connected to ②, ③ or ④ to this jack (pp.14,16).

⑨AUDIO IN

Connect the audio output signal from video equipment connected to ⑤ or ⑩ to this jack.

For a monaural audio signal (a single audio jack), connect it to the L (MONO) jack (p.15).

⑩VIDEO IN

Connect the composite video output signal to this jack (p.15).