Setting
Auto setup
This function enables Input search and Auto PC adjustment by | Auto setup | |
| ||
pressing the AUTO SET button on the remote control. Settings |
| |
for those functions can be altered as follows: |
| |
Input search |
| |
This function detects the input signal automatically. When |
| |
a signal is found, the search will stop. Use the Point ▲▼ |
| |
buttons to select one of the following options. |
| |
Off.......... Input search dose not work. |
| |
On 1....... Input search works under the following situation. |
| |
| – When pressing the AUTO SET button on the |
|
On 2 | remote control. |
|
Input search works under the following situation. |
| |
–When turning on the projector by pressing the
–When pressing the AUTO SET button on the remote control.
–When the current input signal is cut off.*
*If the No show or Freeze function is active, cancel it to activate the Input search. It is also unavailable when
Auto PC adj..
On . . . Enables Auto PC adjustment when pressing the AUTO SET button on the remote control.
Off . . . Disables Auto PC adjustment.
Note:
•While Input search function is set to On 1 or On 2, the status of Input and Lamp are displayed every time the signal is switched.
•Only the last selected input source can be detected.
•If the COMPUTER 1/2 button, VIDEO,
•Auto PC adj. and Input search functions can not be set Off at the same time.
•Fine sync, Total dots, Horizontal and Vertical positions of some computers can not be fully adjusted with the Auto PC adjustment function. When the image is not provided properly with this operation, manual adjustments are required
45
