Setting
Fan
This function provides the following options in the cooling fans’ operation when the projector is turned off (p.20).
L 1...... Normal operation
L 2...... Slower,
normal operation (L1).
Fan control
Choose the running speed of cooling fans from the following options according to the ground elevation under which you use the projector.
Off............ Normal speed. Set this function to Off when
using the projector in
On 1......... Faster than Off mode. Select this mode when
using the projector in high altitudes (about 1,200 meters or more above the sea level) where the fans have less cooling effect.
On 2......... Faster than On 1 mode. Select this mode
when using the projector in higher altitudes than above where the fans have lesser cooling effect.
Video delay control
When you want to make a digital processing of a projected image faster, set this function.
Use the Point ▲▼ buttons, select an item of Off or On.
Lamp counter
This function is used to display the cumulative lamp operating time and reset the lamp counter.
When the total lighting time of a lamp exceeds the recommended total hours of use, the Lamp replacement icon (Fig.1) will appear on the screen, indicating that the end of lamp life is reached.
When replacing the projection lamp, reset lamp counter. See "Resetting the Lamp Counter" on page 64.
Note:
The Lamp replacement icon (Fig.1) will not appear when the Display function is set to Off (p.46), or Freeze(p.25), or No show (p.26).
Note:
•Fan noise becomes louder in On 1 and On 2.
•Failure to set the running speed of cooling fans properly may affect the projector life.
Note:
Noise reduction and Progressive can not be selected when Video delay control function is set to On.
Fig..1 Lamp replacement icon
This icon appears on the screen when the end of lamp life is reached.
Note:
At turning on, the icon (Fig.1) will appear.
57
