Part Names and Functions

Remote Control Battery Installation

1

Open the battery

compartment lid.

Pull up the lid and remove it.

2

Install new batteries into

3

Replace the

the compartment.

compartment lid.

 

Two AA size batteries

 

 

 

For correct polarity (+ and –),

 

 

 

be sure battery terminals are

 

 

 

in contact with pins in the

 

 

 

compartment.

 

 

To ensure safe operation, please observe the following precautions :

●Use two (2) AA or LR6 type alkaline batteries.

●Always replace batteries in sets.

●Do not use a new battery with a used battery.

●Avoid contact with water or liquid.

●Do not expose the remote control to moisture or heat.

●Do not drop the remote control.

●If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

●Risk of an explosion if battery is replaced by an incorrect type.

●Dispose of used batteries according to the instructions.

Remote Control Receivers and Operating Range

Point the remote control toward the projector (to Infrared Remote Receivers) when pressing the buttons. Maximum operating range for the remote control is about 16.4’ (5 m) and 60 degrees in front and rear of the projector.

Infrared Remote Receivers are provided both in front and back of the projector. You can conveniently use both of the receivers (pp. 10, 51)

16.4’ (5 m)

16.4’ (5 m)

Wired Remote Control

The remote control can be used as a wired remote control. Wired remote control helps you use the remote control outside of the operating range (16.4’/ 5 m). Connect the remote control and the projector with the remote control cable (sold separately). Connected with the remote control cable, the remote control does not emit wireless signal.

15