Picture is not bright | – Check if “Contrast” or “Brightness” are adjusted properly. (See page 44) | |
enough.. | – Check if “Image level” is selected properly. (See pages 37, 41) | |
| – Check the Lamp control function. ( See “SETTING” section on page 50) | |
| – Check the Lamp replace indicator. If it lights, the end of lamp life is approaching. Replace | |
| the lamp with a new one promptly. (See page 57) | |
| – The image is darker when 2 lamp mode is selected, compared with 4 lamp mode. Check | |
| the lamp mode at SETTING section on page 50. | |
|
| |
The color is strange.. | – Check the Input signal, color system, video system, or computer system mode. | |
The image is distorted or | – Check “PC Adjust” menu or “ Screen” menu and adjust them. | |
runs off.. |
| |
Auto PC adjustment | – Check the Input signal. Auto PC Adjustment function can not work when 480p, 575p, | |
720p, 480i, 575i, 1035i, or 1080i is selected or when the digital signal is input into DVI | ||
function does not work. | ||
terminal. (See page 34) | ||
| ||
|
| |
The setting does not | – Make sure you selected “Store” after adjusting settings. Some settings can not be stored | |
remain after turning off | ||
if not registered with “Store”. | ||
power.. | ||
| ||
Power management | – Power management function can not work while “Freeze” or “No Show” function is | |
function does not work.. | running. | |
Capture function does not | – Check the connection to see if there is signal. | |
work.. |
| |
Some menus can not be | – Each of the Video Input and Computer Input has a limit on selectable menus. | |
selected.. | ||
| ||
The power is turned off | – Power management function runs by initial setting. Check “SETTING” section on page | |
automatically.. | 51. | |
You can not operate with | – The side control is not available If the side control is locked at “Key lock” under “Security” | |
the side control.. | of SETTING section. Please check “SETTING” section on page 52. | |
Indicators blinks or lights.. | – Check the status of the projector with referring to “ INDICATORS AND PROJECTOR | |
CONDITION” on pages | ||
|
| |
| – Check the batteries. | |
| – Check if the RC sensor is set properly.(See page 51) | |
| – Make sure no obstruction is between the projector and remote control. | |
| – Make sure you are not too far from a projector when using the remote control. | |
The Remote Control does | Maximum operating range is 16.4’ (5m). | |
– Make sure that the remote control code conforms to the projector’s code. | ||
not work.. | (See “SETTING” section on page 50.) | |
| – Make sure the reset switch in the compartment lid on back of the remote control is set to | |
| use position. | |
| – Unlock the Key lock function for the remote control. (See page 52) | |
| – Wireless remote control does not work when the remote control cable is connected to the | |
| projector. (See page 15) | |
|
| |
Unable to unlock the Logo |
| |
PIN code lock, Security | ||
key lock or Security PIN | ||
| ||
code lock.. |
| |
|
| |
Forget the Logo PIN code | ||
or Security PIN code.. |
| |
| ||
appears on the screen |
| |
|
|
63