Safety Instructions
IMPORTANT!
Filter Maintenance!!
The projector uses a lamp which generates significant heat. The cooling fans and air vents are provided to dissipate the heat by drawing air into the housing and the filter is located in the intake vents to prevent dust from getting inside of the projector.
In order to care for the projector appropriately, regular cleaning is required. Remove any dirt or dust that has accumulated on the projector or in the filter.
If the projector reaches a time set in the timer setting, a Filter warning icon (Fig. 1) appears on the screen.
Blocking the air vents and leaving the projector uncleaned for a long time may not only damage the projector and may require costly repairs but may also cause accidents or fire.
For maintenance of the filter, refer to “Filter counter” on page 54 and “Maintenance and Care” on pages 55.
Damages to the projector caused by using an uncleaned filter or improper maintenance will void the warranty on the projector..
Installing the Projector
in Proper Directions
Use the projector properly in specified positions. Improper positioning may reduce the lamp life and result in severe accident or fire hazard.
Positioning Precautions
Avoid positioning the projector as described below when installing.
10˚ | Do not roll the projector more |
| |
| than 10 degrees from side to |
| side. |
10˚ |
|
| Do not point the projector up |
| to project an image. |
NO UPWARD
Do not point the projector down to project an image.
NO DOWNWARD
Fig..1 Filter warning icon
NO SIDEWAYS
10˚
10˚
Do not put the projector on either side to project an image.
Do not pitch the projector more than 10 degrees backward and forward.
CAUTION ON CEILING MOUNTING
For ceiling mounting, you need the ceiling mount kit designed for this projector. When not mounted properly, the projector may fall, causing hazards or injury. For details, consult your dealer. The warranty on this projector does not cover any damage caused by use of any