Setting

Lamp mode

This Projector is equipped with 4 Projection Lamps and the number of using lamps can be switched to 4 lamps or 2 lamps. Using 2 lamps maintains the life of Projection Lamps.

To change over Lamp Mode

Press the Point ed buttons to move the red frame pointer to “Lamp mode”. Set "4 lamps mode" or "2 lamps mode" by pressing the Point 7 8 buttons. When the Lamp Mode is switched from "4 lamps mode" to "2 lamps mode", the image becomes a little darker. When the Lamp Mode is switched from "2 lamps mode" to "4 lamps mode", the image becomes brighter gradually.

Lamp control

This function allows you to change the brightness of the screen.

Auto . . . Brightness according to the input signal.

Normal . . Normal brightness.

Eco . . . Lower brightness. Lower brightness reduces the lamp power consumption and extends the lamp life.

Fan control

Choose the running speed of cooling fans from the following options.

Normal....... Normal speed.

Max............ Faster than the normal speed.

Remote control

The eight different remote control codes (Code 1–Code 8) are assigned to the projector; the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8).

The same code should be set on both the projector and the remote control. For example, operating the projector in “Code 7”, the remote control code also must be switched to “Code 7”.

To change the code for the projector

Select a remote control code in this Setting Menu.

To change the code for the remote control;

Check the Reset Switch to "Use position" in the compartment lid on the back of the remote control.

And then during holding down the MENU button, press the IMAGE ADJ. button corresponding times to the number of the remote control code for the projector. (See page 16)

To reset the code for the remote control;

Slide the Reset Switch to "Reset position" in the compartment lid on back of the remote control.

✔Note:

•After changing the Lamp Mode, it cannot be switched again for 90 seconds.

Remote control

When pressing the SELECT button at Remote control, the Remote control code menu appears.

50