ΝΒ4ΘΡ/ΝΑ (ΣΡΤ−4040 ΓΒ) Τυε. Σεπτ., 10/2002

OUTPUT TERMINALS

SW OUT Terminal

When recording, a pulse signal is output at theSW OUT terminal.

This terminal is usually connected to the switch input (SW IN) of devices like a camera switcher unit, or a quad compressor.

ΦΙΕΛΔ: 16.7 ∝σεχ.

ΦΡΑΜΕ: 5 ∝σεχ.

5V (H)(Output impedance: 5.7 Ω)k 0V (L)

8 Pressl the(orj) button to select“8H the desire

MODE (or 6H MODE)” mode, then press the ENTER button.

œIf “TAPE”the in the (GENERAL SET) menu is set to “T-120”, “6H” will be indicated instead of “8H”.

Y. . . . . . . . . . When recording in 8-hour (or 6-hour) mode, a pulse signal is output.

N . . . . . . . . . When recording in 8-hour (or 6-hour) mode, a pulse signal is not output.

9PressMENUtheEXIT button.
SW OUT Terminal Output Setting

1PressMENUthebutton to display the MAIN MENU.

2 Pressl the(orj) button to select the

“2.DISPLAY/SW OUT SET” line, then press the

ENTER button.

øThe (DISPLAY/SW OUT SET) menu appears.

<DISPLAY@SET>@@@@SET@UP

DATE@@@@@@@@@@@@@Y

TIME@@@@@@@@@@@@@Y

SPEED@@@@@@@@@@@@Y

ALARM@COUNT@@@@@@Y

<SW@OUT@SET>

TIMING@@@@@@@@@@@FIELD

FIELD@@@@@@@@@@@@1

8H@MODE@@@@@@@@@@Y

3 Pressl the(orj) button“TIMING”untilsettingthe

is highlighted, then press the ENTER button.

4 Pressl the(orj) button to select the desired

output timing,ENTERthenbuttonpress. the

FIELD. . . . . . 1 pulse is output after each setnumber of fields.FRAME . . . . 1 pulse is output after each set number of frames.5PressENTERthebutton.

6 Pressl the(orj) button to select the desired pulse

signal interval (1, 2, 3, 4, 5, 10, 30 or 60), then press theENTER button.

œIf“TIMING” is set to FRAME (see step 4), “FRAME” will be indicated instead of “FIELD”.

7PressENTERthebutton.

Ενγλιση

45