Sanyo SRT-4040, SRT-4040DC Back Panel (SRT-4040DConly)

English

NB4QR/NA (SRT-4040 GB) Tue. Sept., 10/2002

LOCATIONS OF CONTROLS AND INDICATORS

Back Panel (SRT-4040DC only)

1

OPEN COLLECTOR

1=500mA(Max.) 2= 50mA(Max.)

3=SEE MANUAL	CONTROL IN 3	EXT TIMER
		(ALARM RESET) IN WARNING OUT 1 TAPE END OUT 2 SW OUT
	ALARM(1 SHOT)IN SERIES IN 3		COM	CONTROL OUT 3 TIMER OUT 3

DC 12-24V IN	AUDIO VIDEO
PUSH	IN
OPEN	IN
REMOTE	OUT
	OUT

PONM L K J I H

With the RS-485 interface board

1B D F H J

A C E G I

SHORT FOR		RS485 A COM		RS485 B
TERMINATION.
	COM		RS485 B	RS485 A
EXT TIMER			WARNINGTAPE	OUENTD OUT1 2 SW OUT
CONTROL IN 3
(ALARM RESET) IN

ALARM(1 SHOT)IN SERIESCOMINCONTROL3 OUTTIMER3OUT 3

23456789FG

1 Battery compartment	1 RS-485 interface board (sold sepa
2 ALARM IN (alarm trigger input) terminal
	A SHORT FOR TERMINATION terminal
1 SHOT IN (single image recording trigger input)
terminal	B SHORT FOR TERMINATION terminal
3 CONTROL IN terminal	C Do not use
	D Do not use
4 SERIES IN (series recording trigger input) terminal
	E COM terminal
5 EXT TIMER IN (external timer trigger input) terminal
ALARM REST IN (alarm recording reset input)
terminal	F RS485 A terminal
	G RS485 B terminal
6 COM terminal
	H COM terminal
7 WARNING OUT (warning output) terminal
	I RS485 A terminal
œ Signals are output when an alarm, clog detection,
	J RS485 B terminal
video loss, non-recording or mechanism problem
occurs.
8 CONTROL OUT terminal	NOTES:
	œ The above illustration shows the unit
9 TAPE END OUT (tape end output) terminal
	RS-485 interface board is installed.
F TIMER OUT (timer recording output) terminal
	interface board is installed, connecto
	A throughJdotonot appear.
G SW OUT (switch output) terminal
	œ The terminal may be damaged by a torqu
H VIDEO IN (video input) jack
	. .
	Nm (5kgcm) or more and by using screwdr
I VIDEO OUT (video output) jack
	tip with a diameter of 6 mm or more.
J AUDIO OUT (audio output) jack
	œ The3,4,8 andFterminals can be used to
	the input and output“SELECTINGsignals. (Ref
K AUDIO IN (audio input) jack
	INPUT AND OUTPUT TERMINALS” on page 38.)
L REMOTE (remote control input) jack
M DC12-24V“+” inputINterminal	œ If using3 and8theterminals, multiple VCRs
	operated by operating a single VCR
N Do not use	“SYNCHRONIZATION CONTROL” on page 40.)
O DC12-24V“–” inputINterminal	œ A fuse has always to be replaced by a
	same ratings (250 V, 5 A)
P Fuse cover

8