
Camera Settings (CAMERA)
A Adjusting synchronization signal (SYNC)
The camera allows you to choose the synchronization signal adjustment method from the following options.
•Internal synchronization (INT) <Initial setting>
Uses internal signal in the camera to adjust synchronization.
•Power source synchronization
Uses the power source frequency to adjust the vertical synchronization phase.
SYNC | INT |
|
IRIS | AUTO | y |
WHITE BALANCE | ATW | y |
BLC | OFF |
|
SHUTTER | OFF |
|
APERTURE | ON | y |
AGC | ON | y |
GAMMA | 0.45 |
|
DAY/NIGHT | AUTO y | |
PRESET | OFF |
|
MENU | BACK |
|
The internal synchronization (INT) is used as an initial setting. In this setting, the vertical synchronization tends to be unstable when multiple cameras are connected through the camera switcher and the camera to be monitored is switched. In this case, use the following steps to adjust the vertical synchronization phase.
1Use the joystick lever (yx) to select [SYNC], use the lever (vw) to select
The
SYNC | y | |||||||||
IRIS | AUTO | y | ||||||||
WHITE BALANCE | ATW | y | ||||||||
BLC | OFF |
| ||||||||
SHUTTER | OFF |
| ||||||||
APERTURE | ON | y | ||||||||
AGC | ON | y | ||||||||
GAMMA | 0.45 |
| ||||||||
DAY/NIGHT | AUTO y | |||||||||
PRESET | OFF |
| ||||||||
MENU | BACK |
| ||||||||
|
|
|
| |||||||
|
|
|
|
|
| |||||
|
|
| ||||||||
[V SYNC PHASE] |
| |||||||||
|
|
|
|
|
|
|
|
| ||
141 | ||||||||||
|
|
| + |
|
|
| ||||
PRESET | OFF |
| ||||||||
MENU | BACK |
|
2Use the joystick lever (vw) to adjust the value so that the image on the monitor does not move up and down when you use the camera switcher.
(Phase adjustment for vertical
synchronization)
[V SYNC PHASE]
+ | 141 |
PRESET | OFF |
MENU | BACK |
☞After completing adjustment, use the lever to move the cursor to [MENU] and select “BACK” or “END”.
Adjustment using power source synchronization is available only for the area where the power supply frequency is 50Hz. This setting will not work in the area where the power supply frequency is 60Hz.
10