Miscellaneous Settings (OPTION)
BSetting the auto flip function (AUTO FLIP)
Rotates the displayed image up or down, left or right electronically when the camera tilts beyond the straight down position.
OPTION | SET | y |
INFORMATION | ||
AUTO FLIP | ON |
|
STABILIZER | OFF |
|
AUTO PURSUIT | OFF |
|
MIRROR | OFF |
|
REFRESH | SET | y |
PRESET | OFF |
|
MENU | BACK |
|
1Use the joystick lever (xy) to select [AUTO FLIP] and use the lever (vw) to select “ON”.
Available settings:
•OFF: Disables the Auto Flip function. (When the tilting angle reaches 90 degrees, the camera stops.)
•ON: Enables the Auto Flip function, allowing you to continue monitoring when the camera is tilted beyond the straight down position.
0 degrees
Normal image
180 degrees
Normal image
90 degrees
ON: Inverse image
Inverse image → Normal image
The image is rotated automatically to change inverse image to normal image.
An image is rotated upside down electronically when the tilting angle reaches around 90 degrees.
(When the Auto Flip takes place, the tilting motion momentarily stops.)
☞After completing setting, use the lever to move the cursor to [MENU] and select “BACK” or “END”.
CCorrecting the sway of the camera
(STABILIZER)
When the base on which the camera is installed (e.g. column, pole or wall) sways, the image from the camera is corrected automatically.
OPTION | SET | y |
INFORMATION | ||
AUTO FLIP | OFF |
|
STABILIZER | ON | y |
AUTO PURSUIT | OFF |
|
MIRROR | OFF |
|
REFRESH | SET | y |
PRESET | OFF |
|
MENU | BACK |
|
1Use the joystick lever (xy) to select [STABILIZER] and use the lever (vw) to select “ON y”, and press the [ENTER] button.
The STABILIZER screen appears.
STABILIZER
LEVELMIDDLE
PRESET | OFF |
MENU | BACK |
Set [STABILIZER] to "OFF" in the OPTION screen when the correction of the sway is not required.
2Uselevel.the joystick lever (vw) to select the correction
The higher the collection level, the more the amount of correction, covering the large sway.
Available settings:
•LOW:
•MIDDLE:
•HIGH:
•The waver correction function may not work depending on the magnitude of waver and/or its frequency.
•The waver correction function does not work while the camera is in motion during such operation or mode as panning, tilting, zooming, automatic panning (AUTO MODE) or moving to a preset position (PRESET GO). However, the waver correction is available when the camera is in resting state, even if any of these functions or modes is selected.
•While the waver is being corrected, the resolution of the image degrades and the angle of the image narrows a bit. The higher the correction level, the lower the resolution, and the narrower the angle.
☞After completing setting, use the lever to move the cursor to [MENU] and select “BACK” or “END”.
50