Camera Settings (CAMERA)

3Use the joystick lever (xy) to select [BURST] and use the lever (vw) to select “ON/OFF”.

If the camera is connected to peripheral devices like frame switcher, burst may occur when the viewing mode is switched between the color mode and the black and white mode. In this case, compensate for the image by inserting the color burst signals.

In general, set this option to “OFF”.

Available settings:

•ON: The color burst signal is turned on.

•OFF: The color burst signal is turned off.

4Use the joystick lever (xy) to select [FOCUS] and use the lever (vw) to select the focus compensation mode.

In general, set this option to “2”. If images are out of focus, set this option to “1”.

Available settings:

•1: Near-infrared wavelength correction (around 900nm) is set during the black and white mode.

•2: Visible light spectrum is set during the color mode.

☞After completing setting, use the lever to move the cursor to [MENU] and select “BACK” or “END”.

While the Day/Night function is set to “AUTO”, the following applies.

•Multi-spot evaluative metering (MULT) selected in the backlight compensation level (BLC) setting works during the color mode.

•The electronic sensitivity boosting (SENSE UP) selected in the lens aperture (IRIS) setting works during the black and white mode.

•The AGC function cannot be set to “OFF”.

bUsing the color mode only (COLOR)

Regardless of the luminance level, only use the color mode to view the image.

1Use the joystick lever (xy) to select [DAY/NIGHT], use the lever (vw) to select “COLOR y”, and press the [ENTER] button.

The D/N SETTING-COLOR screen appears.

D/N SETTING-COLOR

EXT ALARM

OFF

PRESET

OFF

MENU

BACK

2Use the joystick lever (xy) to select [EXT ALARM] and use the lever (vw) to select the channel used for external alarm input.

When [EXT ALARM] is set to “1” - “8”, receiving external alarm input automatically switches the color mode to the black and white mode.

Available settings:

•OFF: Does not switch the color mode to the black and white mode when receiving external alarm input.

•1- 8: Switches the color mode to the black and white mode when receiving external alarm input. (Select an input channel used for external alarm input.)

☞After completing setting, use the lever to move the cursor to [MENU] and select “BACK” or “END”.

20