SATO D512, D508 service manual DIP Switch Settings CONT’D, Switch 4 Unused

Section 3: Configuration and Operation

Switches 1–3: Paper Handling settings These three switches select the method used for controlling paper handling:

Continuous mode - (default mode) Does not use the sensor for paper indexing. The paper movement will stop after all the label data has been printed.

Tear Off mode - Paper is fed out to the cut/tear off position after printing is complete. Before the next label is printed, the paper is pulled back in to the first print line position.

Cutter mode - Enables the Cutter option if installed.

3.3 DIP SWITCH SETTINGS (CONT’D)

Switches 1–3: Font/Graphic loading settings Enables the loading of fonts and/or graphics into printer memory for faster retrieval.

DSW1	DSW2	DSW3	Mode
Off	Off	Off	Continuous
On	Off	Off	Tear Off
Off	On	Off	Cutter
On	Off	On	Reserved
Off	On	On	Load Font

Configuration Switch

ON

OFF

1 2 3 4 5 6 7 8

DSW1 DSW2 DSW3			Mode
Off	On	On	Load Font

Switch 4: Unused

This switch is reserved for future use.

Configuration Switch

ON

OFF

1 2 3 4 5 6 7 8

DSW4 Mode

Off DT

-Reserved

Configuration Switch

ON

OFF

1 2 3 4 5 6 7 8

Page 3-4 SATO D508/D512 Operator Manual