SATO D508, D512 service manual Attributes

Section 1: Introduction

1.1 GENERAL SPECIFICATIONS (CONT’D)

	Attributes
CONTROLS AND SIGNALS
On-Line LED	Green
Power LED	Green
Error LED	Red
LED Display Panel	7-Segment Single Character
On/Off-Line Button	Front Panel
Label Feed Button	Front Panel
Power On/Off Button	Front Panel
Self Diagnostics	Head check
	Paper end
	Cover open
	Test print
POTENTIOMETER ADJUSTMENTS
Adjustment Potentiometers	VR1: Offset level (DIPSW6 = OFF)
	VR1: Print darkness (DIPSW6 = ON)
	VR2: Eye Mark
	VR3: Gap sensor (to adjust the threshold)
	VR4: Label pitch offset
DIP switches	DIP-SW -1,2,3 : Operation mode(Print mode/Download mode)
	DIP-SW -4 : Reserved (constantly OFF)
	DIP-SW -5 : Head check (ON-Enabled / OFF-Disabled)
	DIP-SW -6 : VR1 function switch
	(ON-Print darkness level / OFF-Offset)
	DIP-SW -7 : DATA dump (ON-HEX dump print / OFF-Normal print)
	DIP-SW -8 : Reserved (constantly OFF)
INTERFACE CONNECTIONS
Parallel (Option)	IEEE1284
Serial (Option)	RS232C (up to 57.6K bps) Hardware Flow Control (Ready/Busy) Soft-
	ware Flow Control (X-On/X-Off)
	Bi-directional Status
USB (Option)	USB Specification Version 1.1
LAN (Option)	10/100 Base-T
RFID (Option)	TBA
Wireless LAN (Option)	802.11 b/g (internal)

*All specifications subject to change without notice.

SATO D508/D512 Operator Manual Page 1-5