General Specifications CONT’D, Media

Section 1: Introduction

1.1 GENERAL SPECIFICATIONS (CONT’D)

	Attribute

MEDIA
Media Type	Roll and fanfold
Label Thickness	0.0026” (0.6 mm) - 0.007” ( 0.19 mm)
(Label + backing paper)	*Check with your dealer regarding conditions
	for using thin 0.002” (06 mm) labels
Label Form	Roll Label: Maximum outer diameter of 4.33” (110 mm) face out
	Core Inner Diameter of 1.5” (40 mm)
	Outer Diameter: 4.33” (110 mm)
	Fan-fold label: Max. foldable height: 3.94” (100 mm) loaded externally)
	Wind Orientation: Face-out
Label Size (adhesive labels)	Width for all types:
	1.1” (28 mm) - 4.65” (118 mm)
	For continuous feed:
	Length: 0.71” (18 mm) - 15.75” (400 mm)
	For Cutter usage (optional):
	Length: 1.1” (23 mm) - 15.75” (400 mm)
	For Tear Off mode:
	Length: 0.71” (18 mm) - 15.75” ( 400 mm)

SENSING
See-Through	For die-cut label with gap: Fixed, 0.25" (6.3 mm) from left label edge
Continuous Form	Sensor not used
Eye Mark	Reflective sensor (for use with Pre-printed eye marks)

*All specifications subject to change without notice.

Page 1-4

SATO D508/D512 Operator Manual