Schneider Electric none manual Your Configuration Commands, Command Action Range

3.6 Your Configuration Commands

Each&screen&shows&the&commands that are valid for that screen. You can use either upper or lower case when entering a command.

Command	Action	Range
V	Select a configuration screen or Help screen	1 ... 8
P	Select a port to be configured	1 ... 4
N	Enter a Modbus slave device address	1 ... 247
T	Enter the port type	M = Master
		S = Slave
		N = Network
		X = Silent Master Network
B	Enter the baud rate	50, 300, 1200, 1800, 2000, 2400,
		3600, 4800, 7200, 9600, 19200
S	Enter the stop bits	1 or 2 (Note 1)
R	Enter the parity mode	N = None
		O = Odd
		E = Even
M	Enter the communication mode	A = ASCII
		R = RTU
Y	Enter the port priority	1 ... 4
L	Enter the link timeout value	1 ... 3000, in multiples of 100 ms
F	Enter the modem booster selection	Y = Yes
		N = No
W	Write the configuration parameters to all four ports
D	Initialize all four ports with default parameters
?	Display Help for the current configuration screen
E	Enter a Modbus address and five±byte routing path into	Entry format:
	the Modbus Address Map table on the V2 or V3 screen.	EYY MM XX XX XX XX XX
	When you use this command, enter the following:	where:
	± the E command	E = Modbus Address Map command
	± the table location (1 ... 64) for your entry	YY = location (1 ... 64) in the table
	± the Modbus address (1 ... 255) to be mapped	MM = Modbus address (1 ... 255)
	± the five bytes of routing (1 ... 255 in each byte).	XX = each byte (1 ... 255) in the path.

Notes

￿. Models NW-BM￿￿C002 and NW-BM￿￿D00￿ do not have a

Stop Bits setting. These models default to ￿ data bits with ￿ Stop Bit.

42 Configuring the Modbus Models 31007492