Sears 113.20765 manual Assembly, Assembling Steel Legs, Description Qty, End

Item	Description				Qty,
1	Screw, Serrated Truss			Hd. 114-20 x 5/8.	24
2	Le	Side		:i,:i,ii:	4
3	Stilfener,		...........		2
4	*Lockwasher,		Ext 114	....................	24
5	*Nut, Hex 1t4-20				24
6	Stiffener,	End	..............................		2
7	*Nut, Hex 112-13				8
8	Foot, Leveling			iiiiiii,	4
9	*Washer17/641b_iiiiiiill				ii 4
I0	Screw Hex Hd		1/4-20	x 1-1/4	4

"Parts contained in Loose Parts Bag No 66037

assembly

SPECIAL NOTE: It is normal for this scroll saw to vibrate during operation. For this reason the scroll saw MUST be fastened down securely to a leg set or workbench during operation.

This Leg Set is included with Model No 113,207650 only,

NOTE: For illustrative purposes, the Scroll Saw is

shown mounted on the Craftsman Catalog No 9- 22239 Steel Leg Set

ASSEMBLING STEEL LEGS

1_ insert the Truss Head Screws through the holes

in the legs, then through the holes in the stiffeners, MAKE SURE THE SCREWS GO

THROUGH THE HOLES iN THE SIDE STIFFENERS MARKED "X"

2 Install Iockwashers and screw on the nuts, butdo not tighten until completely assembled

3 Install leveling feet as shown, To level Leg Set, loosen nut on inside of leg and turn nut on outside to raise or'lower feet, Adjust all four levelers, if necessary, and then tighten nuts on inside of leg

NOTE: These levelers are not intended for height adjustment

45

_/10

654 2 !

12

\

3

9

FOR LEG SET

SIDE STIFFNER

END

STIFFNER

SCREWS THROUGH

HOLES MARKED "X"

1/2 IN, HEX NUTS