Sears 113.20765 manual Mounting Scroll SAW to Workbench, Mounting Scroll SAW on LEG SET

MOUNTING SCROLL SAW ON LEG SET

1 Place the Scroll Saw on the Steel Legs, position as shown by aligning the mounting holes in the base of the Scroll Saw with those in the END

STIFFENERS (marked with an X in the illustration)

2 Mount saw to Leg Set using three (3) 1/4-20 carriage bolts, three (3) I/4-20 nuts, three (3)flat washers, and three (3) 1/4" Iockwashers Tighten nuts using wrench

MOUNTING SCROLL SAW TO

WORKBENCH

Anytime the Scroli Saw is in operation, it must be fastened securely to a firm, supporting surface such as a Leg Set (9-22239) or a workbench

When mounting Scroll Saw to a workbench, holes should be drilled through supporting surface of the workbench using dimensions illustrated

!Scroll Saw should be bolted securely using the

following hardware found in Loose Parts Bag: Four (4) 1/4-20 carriage bolts, four (4) 1/4-20

nuts, four (4) flatwashers, and four (4) fockwashers, Bolts must be of sufficient length to accomodate the saw base, rubber bumpers, washers, hex nuts, and thickness of the supporting surface

2 Locate four (4) rubber bumpers in Loose Parts Bag These should be used when mounting Scroll Saw on a solid surface

3 Locate and mark holes where Scrot{ Saw is to be mounted

4 Drill four (4) 5/16" diameter holes through workbench

5, Place rubber bumpers over holes in workbench,

with large opening in rubber bumper against top surface of workbench

6 Place Scroll Saw on rubber bumpers and align holes in workbench, rubber bumpers, and Scroll Saw Base,

7 insert and tighten all four (4) bolts, washers, Iockwashers, and nuts using wrench

		SAW MOUNTING	HOLES
				/
oOO			O	o
			o	O
		o
oo				O
%				O
			0	Oo
O	_--	REAR
o		o	o	o
o			0
o	o			0oO
S			FRONT-_::_

.J

_l

o

O

f,/)_

o l-

Z

o

___5/16" D1A. HOLES (4)

12-1/2"

\ /

PLACE RUBBER BUMPERS

OVER HOLES IN

WORKBENCH

_ CARRIAGE

BOLT

II RUBBER BUMPER