assembly

MOUNTING SCROLL SAW TO

MOUNTING BOARD

An alternate method of mounting is to fasten Scroll Saw to a mounting board The board should be of sufficient size to avoid tipping of saw while in use.

Any good grade of plywood or chipboard with a 3/4" minimum thickness is recommended._

1 Follow instructions for mounting to a workbench, substituting a board 12"x 24" minimum size and using 1/4 inch fiat head screws, Iockwashers, and hex nuts, Screws must be of sufficient length to accomodate saw base, rubber feet, washers, hex nuts, and thickness of supporting board NOTE: Holes must be counter sunk so screw

heads are flush with bottom surface of supporting board

Locate, mark, and drill holes through mounting board, and install screws, iockwashers, and nuts Tighten with wrench

ii

ii llll

ii lllll

ii

ii, ,ll,i

i

 

 

24

_ ....

 

FROM

BOTTOM

__

OF MOUNTING

COUNTER

SINK

 

BOARD

 

.e

 

 

 

p.

 

 

 

J

16" DIA,

HOLES{4)

"_----_

12-1/2

=[

3.Securely clamp board to workbench using C clampsr

NOTE: Supporting surface where Scroll Saw is mounted should be examined carefully after mounting to insure that no movement during use can result, if any tipping or

walking is noted, secure workbench, legs, or supporting surface before operating Scroll Saw.

GUARD

LOCK KNOBS

ADJUSTING GUARD

The Scroll Saw is shipped with a guard arid lock knobs installed

1 Adjust guard by loosening the two (2) guard lock knobs and raising guard to desired height above table Tighten guard lock knobs by hand.

2 Guard should be against top of workpiece to provide additional control, but permit movement of workpiece, flat on table.

GUARD

WORKPIECE

L

INSTALLING MITER LOCK KNOB

1 Locate one (1) miter gauge lock knob, one (1) 13/64 x 5/8 x 1/32 washer, and one (1) wedge among loose parts

2.Insert wedge into tapered recess next to front miter slot

3 Install washer and knob from underside of table,

by engaging knob into wedge.. Tighten knob by hand

NOTE: A miter gauge is included with the Scroll Saw With the wedge locking feature, the

operator can use the miter guage to perform ripping as well as miter and crosscuts.

MITER GAUGE

WEDGE

1

{

t

WASHER

MITER GAUGE,__

LOCK KNOB _J_

MITER GAUGE

Page 8
Image 8
Sears 113.20765 manual Mounting Scroll SAW to Mounting Board, Adjusting Guard, Installing Miter Lock Knob