BLADE DNSTALLATUON AND
TENSIONnNG FOR PLAnN-END OF{ PRN TYPE BLADES
NOTE: Included with the scroll saw are three 5" blades. This saw can accommodate 5" to 6" plain- end blades, and 5" pin type blades.
'TOINSTALL/TENSION PLAIN-END
BLADES:
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF", REMOVE KEY AND REMOVE
PLUG FROM POWER SOURCE OUTLET BEFORE REMOVING OR INSTALLING SAWBLADE.
NOTE: Use blade holder pockets to verify correct blade length and positioning
1 Locate four (4) blade holders, four (4)
(2)extra blade holder assemblies are provided for quick and convenient changing of blades,
2Insert one (1) blade clip into each blade holder by pushing clip through holder until it snaps into place catching upper ledge. Insert one
3insert btade into one holder by pushing short side of blade clip towards set screw, installing blade, and releasing side of blade clip Place holder into blade holder pocket in table (set screw side upward) and check for proper extension squaring blade to opposite blade holder pocket center point Tighten set screw with wrench provided,
4.Insert blade into other holder (as described above) Place both holders in pockets in table to achieve proper spacing and tighten other set screw
5 Place holder assembly in table insert hole; make sure the teeth are pointing downward.
BLADE
SHORT SIDE
BLADE CLIP
BLADE HOLDERS
IN BLADE
HOLDER POCKETS
6Set notches in blade holders into slots inside upper and lower arm end caps The blade holders provide
slots for orientating biade in any 90° position.
NOTE: Blade holders do not touch the retainer clips after being properly installed The purpose of the retainer clips is to deflect the blade holders if the blade breaks
UPPER ARM
END CAP
SLOT IN
END CAP
NOTCHIN
BLAOEHOLDER
9
