Automatic Defrosting

It is not necessary to defrost the beer dispenser. Ice that has deposited on the evaporator is automatically defrosted when the compressor cycles off. The defrosted water collects in the water drip tray located on the top of the compressor in the rear of the unit and evaporates.

Installing the Cleaning Kit

Read and understand the following instructions before installing the cleaning kit.

1.Mix one gallon of warm water and one ounce (one tablespoon) of cleaner in a bucket.

Note: Do not use lye, soap or hot water.

2.Remove the cleaner cap. Fill the jar and replace the cap. Leave the remaining solution in the bucket.

3.Turn off either the air cock on the regulator or the valve on the CO2 tank.

4.Disconnect the tap from the barrel. Then disconnect the beer line from the tap by turning the nut counter-clock- wise. Place the tap and the end of the hose in the bucket.

5.Remove the faucet from the tower with the wrench and attach the fitting on the cleaning bottle in its place.

Note: Make sure there is a washer in the back of the fitting.

6.Hold the cleaning jar upside down until the solution runs through the system into the bucket as shown.

7.Fill the jar with cool clean water and repeat the process until the water runs clear.

8.Rinse the tap in the bucket with cool water.

9.Remove the fitting from the tower and replace the faucet. Make sure the washer is in the back of the faucet.

10.Re-attach the beer hose to the tap and attach the tap to the barrel.

Note: Beer lines should be flushed after each keg is emptied.

CLEANING THE INSIDE

Wash inside surfaces of the beer dispenser with a solution of two tablespoons of baking soda in one quart (0.946 liters) warm water. Rinse and dry. Wring excess water out of the sponge or cloth when cleaning in the area of the controls, or any electrical parts.

Wash the removable parts with the baking soda solution mentioned above, or mild detergent and warm water. Rinse and dry. Never use metallic scouring pads, brushes, abrasive, cleaners, or alkaline solutions on any surface. Do not wash removable parts in a dishwasher.

CLEANING THE OUTSIDE

Wash the cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth. Replace parts.

WARNING If leaving the beer dispenser door open while on vacation, make certain that children cannot get into the beer dispenser and become entrapped.

9

Page 10
Image 10
Sears 183.91579 manual Cleaning The Inside, Cleaning The Outside, Automatic Defrosting, Installing the Cleaning Kit