Sears 183.91579 manual

2.Attach the CO2 regulator to the CO2 cylinder by screwing the regulator nut onto the cylinder valve and tightening with an adjustable wrench.

3.Remove the bolt with the nut from the cylinder retainer. Using two screws attach it inside the unit on the left side of the back wall. (Holes are pre-drilled and screws are included)

4.Slide the cylinder through the retainer and secure it with the bolt and the nut. Position the cylinder so that you will be able to read the numbers on the gauge and

easily access the shut-off valve and pressure adjustment screw.

Connect to the CO2 Cylinder

CO 2

Regulator

Gauge

Pressure

Adjustment

Screw

Clamp

CO2 Cylinder

Shut-Off Valve

Follow the steps below to tap the keg of beer.

1.Make sure the pull handle of the Sankey Tap is in the closed (up) position before installing it on the beer keg. (see fig.1) Insert the keg coupler into the locking neck of the beer keg and turn clockwise 1/4-turn to lock it into position. (see fig. 2)

fig. 1 Pull handle (upward)

Coupling Head

Plastic Insert

Connect to the CO2

Gas Line Tube Barb

Keg Coupler

fig. 2						I
					W SE
				K
			C
		O
	L
	C
	N
	R
T	U

Connect to the Keg Tap (coupler)

CO2

GAS

Retainer

WARNING!

CO2 can be dangerous! CO2 cylinders contain high-pressured gas,

which can be hazardous if handled improperly.

They must be handled with care.

Tapping the Beer Keg – Installing Keg Tap (Single-Valve Type Barrel)

Your beer dispenser comes with American Sankey Tap. This type is the most widely used in the United States. Before purchasing a keg, check with your beer distributor to make sure that supplied Sankey Tap can be used.

Note: For European draft beer, European Sankey Tap is required. Please contact Draught Technologies by visiting www.draughttech.com or call

(860) 677-7312.

Beer Keg Neck

2.IMPORTANT: You must insert the black rubber washer into the beer line coupling nut before screwing the nut onto the keg tap coupling head. First remove the black protective shipping cap from the coupling head. Do not remove the plastic insert from the coupling head. Insert the black washer inside of the coupling nut. Firmly hand-tighten the coupling nut onto the coupling head. (see fig. 3)

3.Attach the open end of the red tube to the hose barb connection on the Sankey Tap. Next, secure the tube by using the remaining self-locking plastic snap-on clamp to ensure that there are no leaks. Secure the clamp tightly with pliers. (see fig. 3)

fig. 3

Beer Line

Coupling Nut

Red Tube (gas line)

5