VACATION AND MOVING TIPS
Short Vacations:
Leave the beer dispenser operating during vacations of less than three weeks.
Long Vacations:
If the beer dispenser will not be used for several months:
•Unplug the power cord.
•Clean and dry the interior thoroughly.
•Leave the beer dispenser door open slightly, blocking it open if necessary, to prevent odor and mold growth.
Moving:
When moving the beer dispenser, follow these guidelines to prevent damage.
•Disconnect the power cord plug from the wall outlet.
•Remove keg, and clean the beer dispenser.
•Secure all loose items such as the basket and the shelves by taping them securely in place to prevent damage.
•In a moving vehicle, secure beer dispenser in an upright position to prevent movement. Also protect outside of beer dispenser with a blanket, or similar item.
POWER FAILURE/BEER DISPENSER FAILURE
NOTE: Do not open beer dispenser door unnecessarily if beer dispenser is off for several hours.
If the beer dispenser has stopped operating, see Beer Dispenser Does Not Run in the Troubleshooting Guide.
KEG CONNECTIONS – TANK REPLACEMENT
How do I replace an empty C02 tank?
1.Close tank drum valve by turning clockwise.
2.Unscrew adjustment Set Screw
3.Remove regulator from empty tank.
4.Remove dust cap from the new full tank. Open and close drum valve quickly to blow of the dust from the outlet.
5.With drum valve in closed position, reattach regulator to the tank. Be sure to check the washer, which is
6.Open drum valve all the way. (This is important because this drum valve seals in two places.)
7.Readjust regulator pressure by turning set screw and open shut off valve.
Tank Information: Tank must always be fastened in the upright position. It takes about 1/2 lb. of C02 to dispense 1/2 barrel keg of beer. A 5 lb. C02 tank should dispense between
Keg Coupler
(Sankey Type) Low Pressure
Gauge
Beer Line | Regulator | Regulator |
| ||
| Coupling Nut | |
|
|
Drum Valve
Set Screw
CO2 Tank
Air Line
Shut off Valve
10
