HOW to Adjust the Drive Belt | Sears 23897 manual

HOW TO ADJUST THE DRIVE BELT

If you can feel the pedals slip while you are pedaling, even when the resistance is adjusted to the highest level, the drive belt may need to be adjusted.

See EXPLODED DRAWING B on page 37. Remove the M4 x 16mm Screws (93) and the M4 x 42mm Screws (124) from the Right and Left Shields (18, 19).

Make sure to note which size Screws come from which holes. Then, carefully remove the Left Shield.

To adjust the drive belt, first unplug the power cord. Using a flat screwdriver, release the tabs on the Top Cover (20) and pry the Top Cover upward off the elliptical.

	20
13	19, 18
13	136
	117
	124

Next, lift the Latch (117) on the underside of the Left Pedal Arm (13), and then lift the Left Pedal Arm off the left Sleeve (136).

Loosen the Pivot Screw (97). Tighten the Belt Adjustment Screw (85) until the Drive Belt (38) is tight. When the Drive Belt is tight, tighten the Pivot Screw.

38

97

85

When you are finished, reattach the left shield, replace the left pedal arm, and reattach the access cover. Then, plug in the power cord.

30

Image 30

Sears 23897 user manual HOW to Adjust the Drive Belt

Contents

QUESTIONS? Model No Serial NoCall TOLL-FREE Table of Contents Important Precautions Before YOU Begin Part Identification Chart Assembly Avoid pinching Upright WireWire with the wire tie Tip Avoid pinching the Upright Wire Screws yet Do not press the Top Cover 23 into place yet Tip Avoid damaging the Upright Wire Avoid damaging Screws yet Tighten the two M6 x 12mm Screws See the upper drawing. Locate the Ramp See the lower drawing. Pull upward on 111 Wires Tip Avoid pinching the wires. Attach the RearRepeat this step on the other side Elliptical Repeat this step on the other side of the elliptical See the inset drawing. Locate the Pulse Wire Avoid pinching Wires HOW to USE the Elliptical HOW to Plug in the Power CordPage HOW to Exercise on the Elliptical HOW to Level the Elliptical Console Diagram Features of the Console Select the manual mode HOW to Turn on the PowerHOW to USE the Manual Mode Follow your progress with the display About the optional chest heart rate monitor Measure your heart rate if desiredHeart rate monitor see page 26 for information Same time, the console will not display your When you are finished exercising, unplug the power cord Turn on the fan if desired HOW to USE AN Onboard Workout Select an onboard workoutBegin pedaling to start the workout HOW to USE a SET-A-GOAL Workout Set a calories, distance, or time goal Select a user Select an iFit workout HOW to USE AN Ifit WorkoutMake sure that the iFit module is inserted in the console Start the workout. See on HOW to USE the Sound System Follow your progress with the display. See onOptional Chest Heart Rate Monitor HOW to Change Console Settings FCC Information Heart Rate Monitor Troubleshooting Maintenance and TroubleshootingHOW to Adjust the Reed Switch HOW to Calibrate the Ramp HOW to Adjust the Drive Belt Workout Guidelines Exercise GuidelinesExercise Intensity Exercise Frequency Suggested Stretches Page Part List Description Qty Qty Description Exploded Drawing a Exploded Drawing Exploded Drawing C 126 102 Ordering Replacement Parts Limited WarrantyIcon Health & Fitness, Inc., 1500 S W., Logan, UT