Part Identification Chart | Sears 23897 manual

PART IDENTIFICATION CHART

Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it has been preassembled. Extra parts may be included.

M6 x 13mm		M8 Split	M8 x 25mm x	M17 x 27mm
Washer (140)–8		Washer	1.5mm Washer	Wave Washer
		(131)–8	(126)–4	(88)–2
M4 x 16mm	M8 Locknut		M6 x 12mm	M6 x 50mm
Screw (93)–14		(105)–6	Screw (139)–4	Screw (62)–4
M8 x 16mm		M8 x 25mm		M8 x 45mm Bolt
Screw (102)–12		Screw (128)–2		(104)–6
			M10 x 120mm
			Screw (100)–4

5

Image 5

Sears 23897 user manual Part Identification Chart

Contents

Call TOLL-FREE QUESTIONS?Model No Serial No Table of Contents Important Precautions Before YOU Begin Part Identification Chart Assembly Wire with the wire tie Tip Avoid pinching the Upright Wire Upright WireAvoid pinching Screws yet Do not press the Top Cover 23 into place yet Avoid damaging Tip Avoid damaging the Upright Wire Tighten the two M6 x 12mm Screws Screws yet See the lower drawing. Pull upward on See the upper drawing. Locate the Ramp 111 Repeat this step on the other side Elliptical WiresTip Avoid pinching the wires. Attach the Rear Repeat this step on the other side of the elliptical See the inset drawing. Locate the Pulse Wire Avoid pinching Wires HOW to Plug in the Power Cord HOW to USE the EllipticalPage HOW to Level the Elliptical HOW to Exercise on the Elliptical Features of the Console Console Diagram HOW to USE the Manual Mode HOW to Turn on the PowerSelect the manual mode Follow your progress with the display Heart rate monitor see page 26 for information Measure your heart rate if desiredAbout the optional chest heart rate monitor Same time, the console will not display your Turn on the fan if desired When you are finished exercising, unplug the power cord Begin pedaling to start the workout HOW to USE AN Onboard WorkoutSelect an onboard workout Set a calories, distance, or time goal HOW to USE a SET-A-GOAL Workout Make sure that the iFit module is inserted in the console HOW to USE AN Ifit WorkoutSelect a user Select an iFit workout Start the workout. See on Optional Chest Heart Rate Monitor HOW to USE the Sound SystemFollow your progress with the display. See on HOW to Change Console Settings FCC Information HOW to Adjust the Reed Switch Maintenance and TroubleshootingHeart Rate Monitor Troubleshooting HOW to Calibrate the Ramp HOW to Adjust the Drive Belt Exercise Intensity Exercise GuidelinesWorkout Guidelines Exercise Frequency Suggested Stretches Page Description Qty Part List Qty Description Exploded Drawing a Exploded Drawing Drawing C Exploded 126 102 Icon Health & Fitness, Inc., 1500 S W., Logan, UT Ordering Replacement PartsLimited Warranty