4. Identify the Right Upper Body Arm (8) and the | 4 |
|
|
|
|
Right Upper Body Leg (6) and orient them as |
|
|
|
| |
|
|
|
|
| |
shown. |
|
|
|
|
|
Insert the Right Upper Body Arm (8) into the |
|
|
|
|
|
Right Upper Body Leg (6). |
|
|
|
|
|
Attach the Right Upper Body Arm (8) with three |
|
|
|
|
|
M8 x 45mm Bolts (104) and three M8 Locknuts | 9 |
|
|
|
|
(105). Make sure that the Locknuts are inside |
|
|
|
| |
|
|
|
|
| |
the hexagonal holes. Do not fully tighten the |
|
|
|
|
|
Bolts yet. |
|
|
|
|
|
Assemble the Left Upper Body Arm (9) and |
|
|
|
|
|
the Left Upper Body Leg (7) in the same way. |
|
|
| 8 |
|
| 104 |
| 104 |
|
|
| 105 |
|
|
| |
|
| 105 |
|
| |
|
|
|
|
| |
|
|
|
|
| 104 |
|
| Hexagonal |
|
| |
|
|
| Holes | 6 |
|
|
|
|
|
| |
| 7 |
|
|
|
|
5. Using a small plastic bag to keep your fingers | 5 |
|
|
|
|
clean, apply a generous amount of the included |
|
|
|
| |
grease to the Upright Axle (48) and to two M17 x |
|
|
|
|
|
27mm Wave Washers (88). |
|
| Avoid damaging the | ||
Tip: Avoid damaging the Upright Wire (60). |
|
| Upright Wire (60) |
| |
Insert the Upright Axle (48) through the Upright |
|
|
|
|
|
(5) and center it. Slide an M17 x 27mm Wave |
|
|
|
|
|
Washer (88) onto each side of the Upright Axle. | 9 |
| 60 |
|
|
Slide the Right and Left Upper Body Arms |
|
|
| ||
102 | 88 |
| 5 |
| |
(8, 9) onto the right and left sides of the Upright |
|
| |||
Axle (48). | 126 |
| 48 |
|
|
|
|
|
| ||
Tighten an M8 x 16mm Screw (102) and an M8 |
|
|
| 88 |
|
x 23mm x 1.5mm Washer (126) into each end of |
|
|
| 8 | |
the Upright Axle (48) at the same time. |
| Grease |
| ||
|
| 126 | |||
|
|
|
|
| |
|
|
|
|
| 102 |
| 8 |
|
|
|
|
