Sears 23897 Avoid pinching, Upright Wire, Screws yet Do not press the Top Cover 23 into place yet

2.	Orient the Front Stabilizer (3) as shown.	2
	While a second person lifts the front of the	3	100
	Frame (1), attach the Front Stabilizer (3) with
	two M10 x 120mm Screws (100).
		1
3.	Identify and orient the Upright (5) and the Top	3
	Cover (23) as shown.

Slide the Top Cover (23) upward onto the		Wire Tie
Upright (5).
			Avoid pinching the
Have a second person hold the Upright (5) and
			Upright Wire (60)
the Top Cover (23) near the Frame (1).
Locate the wire tie in the Upright (5). Tie the			5
lower end of the wire tie to the Upright Wire (60).
Next, pull the upper end of the wire tie until the			23
Upright Wire is routed through the Upright.
Tip: To prevent the Upright Wire (60) from
falling into the Upright (5), secure the Upright		102
Wire with the wire tie.
Tip: Avoid pinching the Upright Wire (60).		Wire Tie
		131	60
Slide the Upright (5) onto the Frame (1).
		1
Attach the Upright (5) with eight M8 x 16mm			131
Screws (102) and eight M8 Split Washers (131)			102
(only four of each are shown); do not tighten
	102	131
the Screws yet.

Do not press the Top Cover (23) into place yet.

7